Page 128 of 128 FirstFirst ... 2878118126127128
Results 1,906 to 1,919 of 1919
  1. #1906
    BLOOOOOOOD!!!! Manabir's Avatar
    Generation
    Non Honda
    Model
    AUII XR8 220
    Join Date
    Jan 2005
    Location
    Victoria
    Posts
    3,667
    not today, did it a few days ago, but i hooked up a bluetooth handsfree to the factory headunit.
    rewired the tape player to get its signal from a aux-in cable instead of a tape.
    hooked up the bluetooth unit from jaycar to the lighter power and the aux-in cable.
    ran the mic wire under the dash and attached it to the a pillar.
    done.
    bluetooth audio comes through the stereo when the unit is on "tape". both calls and music streaming.


    A completed modified car is an ever changing goal that can never truly be achieved.
    CLICK to see my progress towards this impossible end.

  2. #1907
    Silver Member Kozman91's Avatar
    Generation
    3rd Gen
    Model
    JDM Si 4ws
    Join Date
    Dec 2010
    Location
    Victoria
    Posts
    1,437
    Today I finally decided to put the car up on jack stands and fix a really really annoying exhaust leak.
    Took out the hurricane manifold and downpipes, resealed with fresh gaskets and plenty of RTV silicone. Job Done!
    Also discovered where I've been losing oil. Bottom of the dipstick shaft was leaking under pressure, Siliconed that in aswell

  3. #1908
    Regular Member Gregsir's Avatar
    Generation
    4th Gen
    Model
    Si-Vtec
    Join Date
    Dec 2011
    Location
    Queensland
    Posts
    225
    I had my window fail the other day,hottest day in a while and the motor started buzzing and the switch was unresponsive.
    Why does it happen when the window is down!
    2 days without the car till i got the swap of the regulator from old blackies door,all good now,big clean tomorrow and hopefully time to get the new rotors on before work.

  4. #1909
    Regular Member Gregsir's Avatar
    Generation
    4th Gen
    Model
    Si-Vtec
    Join Date
    Dec 2011
    Location
    Queensland
    Posts
    225
    Stripped a donor 4G of all its goodness for my own car.
    Owner was a pro sprayer for BMW and had done a whole front end spray recently before he had got engine trouble,
    1 happy receiver,so looking forward this tidy up.
    SDC13180.jpg

  5. #1910
    Senior Member Tommzor's Avatar
    Generation
    3rd Gen
    Model
    Si 4ws
    Join Date
    Oct 2010
    Location
    Victoria
    Posts
    517
    Got in it, looked around a bit, found my 10mm 1/4" deep socket that's been missing for a day and a half

    Then went back to fixing dunnydoors and various other shitboxes
    Grip > Slip.

    1989 Honda Prelude SI.4WS, Pheonix Red - SSV-135 / PR3LDE - Rust in Peace.
    1989 Honda Prelude SI.4WS, Polar White - PR3LDE - Rust in Peace.
    1987 Honda Prelude JDM SI.4WS - Granada Black - Work in progress.
    2002 Mitsubishi Lancer CE Coupe - Amethyst Black Pearl - Daily.

  6. #1911
    Senior Member Sean628's Avatar
    Generation
    3rd Gen
    Model
    Si 4ws
    Join Date
    Mar 2011
    Location
    Victoria
    Posts
    945
    went to see my old white cita I gave away this Feb, missing few parts but I'm bring it back this wkends

  7. #1912
    Junior Member
    Generation
    4th Gen
    Join Date
    Feb 2015
    Location
    United States
    Posts
    4
    i want to go on long drive with my car.

  8. #1913
    Silver Member Terry_GT-R34's Avatar
    Generation
    4th Gen
    Model
    VTiR
    Join Date
    Aug 2008
    Location
    New South Wales
    Posts
    1,423
    Any good driving roads where you are Harry? What's your locality like?

    Best Shape Award = 4th Gen Prelude + Best Bang For Your Buck Award = R34 GT-R N1

  9. #1914
    Regular Member tassie_bb1's Avatar
    Generation
    4th Gen
    Model
    VTEC
    Join Date
    Dec 2013
    Location
    Tasmania
    Posts
    205
    What did I do to MY car on the weekend? Changed the ignition leads, dizzy cap and rotor, fuel filter, started working out the wiring for the 4WS delete and new brackets for my sunroof delete, filled the rust hole in the old sunroof panel, bogged and primed the whole thing (including the 4x seal brackets on the underside) all ready for painting.

    Then I spent 6 hours banging on these F#*&^@*&#*@!^ing driveshafts on my wife's 121 Khanacross car trying to remove them ready for new ones to go in.... aaaaand they're still in there. Screw working on Mazda's, Honda's are so much easier.
    Symmons Plains - 1:12.280

  10. #1915
    Regular Member Gregsir's Avatar
    Generation
    4th Gen
    Model
    Si-Vtec
    Join Date
    Dec 2011
    Location
    Queensland
    Posts
    225
    I don't know about those driveshafts on the Hondas been any better tassie,the trouble i had getting mine off was terrible,i had a mate help and the car was moving on the stands with the amount of wrench work and banging going on!
    I just refitted my oem sideskirts after some colour coding and they look good,wanted to do them for ages,such a dope when i realised after all the pulling all i needed to do was slide them off,arghhh.

  11. #1916
    Silver Member renzokukenj's Avatar
    Generation
    5th Gen
    Model
    Si
    Join Date
    Jul 2009
    Location
    Western Australia
    Posts
    1,047
    Threw a brick at mine, now wondering how to get the dent out of it
    ʍǝɹɔ uʍop ǝpısdn

    私の進行中のスレッドを確認してください
    Quote Originally Posted by lommytam2342 View Post
    Hey Furo, whats the finger spacing for your rear?
    Quote Originally Posted by Son of Eevil View Post
    How much do I have to pay you or how much dick do I have to suck to get you to take me for a ride?!

  12. #1917
    Regular Member tassie_bb1's Avatar
    Generation
    4th Gen
    Model
    VTEC
    Join Date
    Dec 2013
    Location
    Tasmania
    Posts
    205
    Eh, it'll buff out.
    Symmons Plains - 1:12.280

  13. #1918
    Junior Member Zak's Avatar
    Generation
    5th Gen
    Model
    VTI-R
    Join Date
    Feb 2015
    Location
    New South Wales
    Posts
    135
    Quote Originally Posted by renzokukenj View Post
    Threw a brick at mine, now wondering how to get the dent out of it
    dafuq

  14. #1919
    Silver Member renzokukenj's Avatar
    Generation
    5th Gen
    Model
    Si
    Join Date
    Jul 2009
    Location
    Western Australia
    Posts
    1,047
    Quote Originally Posted by Zak View Post
    dafuq
    das it
    ʍǝɹɔ uʍop ǝpısdn

    私の進行中のスレッドを確認してください
    Quote Originally Posted by lommytam2342 View Post
    Hey Furo, whats the finger spacing for your rear?
    Quote Originally Posted by Son of Eevil View Post
    How much do I have to pay you or how much dick do I have to suck to get you to take me for a ride?!

Similar Threads

  1. Skinnyboy's Progress Thread
    By skinnyboy in forum Projects
    Replies: 819
    Last Post: 8th December 2009, 02:03 AM
  2. The 3rd gen list
    By SAKI in forum General Automotive Discussion
    Replies: 36
    Last Post: 3rd September 2008, 01:45 AM
  3. Honda wins 2007-2008 Japan Car of the Year Award
    By racinghonda in forum Honda News
    Replies: 15
    Last Post: 5th January 2008, 12:36 PM
  4. car immobilizer flashing help!
    By bdesigns in forum Fifth Generation
    Replies: 10
    Last Post: 2nd February 2007, 11:35 AM
  5. December 06 - Car of The Month - Skinnyboy
    By Lavish in forum Car of the Month
    Replies: 60
    Last Post: 11th December 2006, 10:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •