Search:

Type: Posts; User: H22A LUDE

Search: Search took 0.01 seconds.

  1. Replies
    8
    Views
    6,576

    Sticky: Been a while, some more dyno plots to throw up...

    Been a while, some more dyno plots to throw up for reference. Different prelude to the one above- 1992 BB4 manual with 272k kms.

    In 100% stock trim (252k kms):...
  2. Replies
    133
    Views
    58,367

    Sticky: I am just reporting what I experienced a few...

    I am just reporting what I experienced a few years ago, I cant explain why the oil did what it did but it was specific to that one container I tried and I have never gone back to try another. The oil...
  3. Replies
    133
    Views
    58,367

    Sticky: Milkiness was only when running pennzoil oil when...

    Milkiness was only when running pennzoil oil when the engine had ~180k km; the same engine has now done 240k km (still unopened) and is still running strong. For what ever reason the oil was breaking...
  4. Replies
    133
    Views
    58,367

    Sticky: I have tried a fair few oils now within the H22A....

    I have tried a fair few oils now within the H22A. I have tried some 5w 40 (like Castrol EDGE and Helix Ultra) but they were far too watery for my H (oil vanished into thin air and the valves were...
  5. Replies
    8
    Views
    6,576

    Sticky: Two plots I can contribute from my 1991 BB1 H22A...

    Two plots I can contribute from my 1991 BB1 H22A with ~240k kms (note- automatic gearbox):
    First plot: 7585
    94.6wkw---Blue line mods (was running way too lean...)
    Mods:
    CAI- Simota filter...
  6. I have now fully tested the oil feed line. There...

    I have now fully tested the oil feed line. There is definitely oil pressure where the oil feed is, even when the car isn't on Vtec. I took off the sensor and started the car while cold and a got a...
  7. No oil pressure reading after oil pressure gauge install

    I'm looking at fitting a new head onto my H22A block but the head is off a newer H22A (P5M) head and mine is P13 block. Anyone ever done this swap? I know the old block is closed deck and the new one...
  8. No oil pressure reading after oil pressure gauge install

    Hey

    I have just installed an oil pressure gauge onto my H22A following the instructions of ChrisRicketts' post. Very neat place to put it, plus it makes it easy to check for leaks etc. Now i have...
Results 1 to 8 of 8